Now that you have located the learn button of your opener, it is time to use it.

Reprogramming a clicker garage door opener. Both leds on the garage door opener will light up purple. Look for the program button, then press and hold it until an led light goes on. Press the ‘learn’ button again and thereafter you will see the light come.

If the light flashes, don’t be alarmed. Once it’s been reset, you. Locate the learn button on the.

On the clicker keypad, enter the pin from step 1, and press and release the 0 key. This will activate the garage door opener and programming is complete. Hold down the learn button on the garage door opener for 3 seconds with the door open.

To reset your clicker garage door keypad, you need to find the learn button. Program accessories to the opener.; This indicates that the unit has forgotten the old code.

Follow these steps to reprogram any garage door clicker with a keypad clicker. Climb a ladder to reach it on the motor unit and. This button is usually located on the back of the unit.

The light will blink green to indicate that it is in programming mode. Clicker garage door opener reset. This just means that your opener is ready to sync with your.