Install the exterior keypad 5.

Reprogram kwikset digital deadbolt. Install the latch and strike 4. Release the set enter your current master code. Prepare the door and check dimensions 3.

Press and hold the kwikset halo’s “program” button while reinserting the battery pack. If programming is unsuccessful, the “x”. You will hear one long beep.

Kwikset low battery read review. If programming is successful, the checkmark will illuminate and you will hear one beep. Put the two phillips screws in your container.

In short, here’s what to do if your kwikset lock won’t work after replacing batteries: Enter the default/current programming code and press the. As a test, rotate the turnpiece on the deadbolt so the latch is retracted (unlocked), and close the door.

Adding/creating user codes to a defiant electric deadbolt. Use the phillips screwdriver to remove the two mounting screws from your kwikset deadbolt lockset. Enter the 0000 programming code and then press the kwikset button once.

Check that the batteries are correctly installed—following the correct polarity. If you have to push, pull or lift the door to get it to close, adjust. Make sure the lock is in the unlocked position.