Remove the old shower valve.

Replace two handle shower valve. Mark the cover hole on the tile and cut it out with an abrasive blade in a jigsaw. Loosen the screws with a screwdriver and take the cap off. Before installing the new shower diverter valve, clean the inside of the shower diverter valve opening using a rag dipped in vinegar.

Fixing a faulty valve with this old house plumbing and heating expert richard trethewey. If it is stuck, chip away at grout and plaster from. Shut off the water to the shower by turning the valves on the water supply lines to the “off” position.

So now what we’re going to do is we’re also going to get me a seat. Replacing and installing your shower valve. Install the new valve and properly.

(see below for a shopping list and tools.)subscribe to this old hous. The first thing you want to do when you confirm your shower valve is faulty is to turn off the source that runs water to your shower. Always remove the tub and shower.

Remove the old valve by unscrewing the. Next, remove the handles and stems before removing the old valve. Standard valve will have lever handles or knob handles.

You can just replace the the actual washers itself, but in this case we’re gonna go ahead and replace the entire body. A two or three handle shower: Pop open the cap with a flathead screwdriver and unfasten the set screw.