The broken command strip tabs.

Removing 3m command strips. Press two strips together until they click. To get rid of the smeared petroleum jelly, apply few drops of dish soap. This will remove some of the residue but may not remove all of it.

Place the lower pair of strips. Step 2 press another piece of tape over the adhesive and pull the tape off. The part # 17021p is for the slightly thicker white foam medium 3m command strip.

Slide the floss under the top of the command strip, and move back and forth as you move down the strip, acting gently and slowly. Place the lower pair of strips. Wiggle it down behind until it reaches the bottom.

Rub the bits with petroleum jelly. Make sure the temperature of the water is safe for. Spray both sides of the blade generously with lubricant.

Removing the command strips from the wall note: Grab bottom corners and peel frame from wall. The part # 17021clr is for the clear medium 3m command strip for smooth to semi smooth surfaces.

Carefully work the edge of the blade under one corner of the sticky tape. Accidentally ripped the pull tab off your 3m command strip? Learn the proper way to remove command™ picture hanging strips so they won't damage your wall.