Without cooling it, transfer it to a spray bottle.

Remove vinyl floor tile adhesive. Now that you have applied some heat, the tile should be easier to remove. You need a hot air gun or a hairdryer to heat and loosen the adhesive on the bottom of the vinyl for easy. If there is a lot of glue, you may want to push the glue onto a.

First, take 100 ml white vinegar and heat it without bringing it to a boil. Please turn it on low and wait for it to warm up. Apply it according to the directions, and allow enough time for it to sit on the adhesive and work.

Next, locate a section of the floor with no glue underneath. Clean on the surface of the vinyl where the glue is. Then spray this over the adhesive and wait.

Mix well until bubbles show up. Take a dry sponge and dip it into the solution. Before removing the tiles from the water, make sure the adhesive is soft to touch.

If necessary, increase the setting. Take some warm water in a bowl and add a few drops of dish liquid. Fill a bucket or later with warm water.

Start removing vinyl flooring right here, using a utility knife to cut the material into. Apply the gun to the glue and wait for it to soften. No one likes seeing original hardwood floors covered in vinyl flooring or ceramic tiles.