To change a new genie wireless keypad from series ii to series i mode follow these steps:
Programing genie wireless keypad. Press and hold “prog” and “8” while fully opening cover. To reset the intellicode wireless keypad. On the keypad enter new pin number.
Genie's new universal wireless keypad will program to most brands of garage door openers. The keypad is now programmed to operate this opener. Part 1 open the genie intellicode keypad cover halfway.
Hardwired keypads slide switch on the receiver box on the inside of the garage to program. Part 1 to reset your genie of fairview intellicode wireless keypad follow these steps open cover half way. Press the enter key, then enter the personal code of your choice (up to 6 digits) and press enter.
Choose from belt drive, chain drive and screw drive operators. Genie recommends that you program the wireless keypad before mounting it to the wall. Press the prog and 8 buttons simultaneously and hold them.
Erase the other garage door codes note how the genie is. While holding the # and 8 buttons slide the keypad cover. Press and hold both the “prog” and “8” keys.
(red led flashes 1 time per second) 2. Choose the model of your remote or keypad accessory to find the correct programming instructions. Slide the keypad cover to half way open.