Press the program button the number of times that matches the code position.
Program kwikset lock. If programming is successful, the checkmark will illuminate and you will hear one beep. Use the program button and hold it until the keypad flashes green. Keep holding the button for 30 seconds until the lock beeps and the status.
Press or swipe down the clock display at the top for the settings tray. Remove the interior side cover by sliding it up. Enter your new master code.
Open the door and extend the bolt. There may be side screws holding it in place, if so remove. You can make guesses, but each three consecutive failed attempts will result in the powerbolt 2 locking out for 60 seconds.if you forgot your user code, there are two options:1.
Press and hold the program button while reinserting the battery pack. How to program the kwikset 910 door lock to the iq panel 2. Enter the code you want to delete.
How to enable or delete the master code on a kwikset lock. Allow the lock to run the program. Enter the 0000 programming code and then press the kwikset button once.
Remove the battery pack by pulling. Press settings for user menu, then select advanced. If programming is unsuccessful, the “x” pattern will fl ash three times with.