Get it as soon as Fri Jun 25.

Pontoon motor trim. 50 out of 5 stars 2. The Panther Integral Trim and Tilt is designed for use with Johnson and Evinrude 20HP to 35HP outboard motors made since 1976. To trim the motor means to move it up and down.

If you have a large enough engine to run strakes pontoons much more efficient and speedy. Pontoon boats with smaller engines are expected to go with shorter shafts. When you trim down it brings the lower unit back towards the boat.

Point the drive unit first and then shift. Honda motors sold separately come with tac tilt gauge ONLY. You can try the trim button on the motor but it porbably pulls the same power trim relay s as the switch in the control.

Its doubtful that trim is that important on a pontoon without strakes as pontoons essentially are plowing through the water. On hydraulic models trim is usually activated while the motor is running and in gear. You could use a short shaft engine and in shallow water youd raise the engine by pulling up on the lever.

Tilting the motor up and down is usually done with the motor turned off or in neutral. The boat is an old flounder giggi. Tilt Trim Motor for Yamaha OMC Evinrude Johnson Outboards Female Spade Terminals 434495.

I have been on toons with IOs and large 250- 300 hp outboards and even on them trim has a. Exoman ordered the CMC PT-35 Tilt and Trim Plate. This how to video is narra.