At this time we do not have an appropriate transom for mounting a tiller steer outboard engine on our pontoon boat kits with 26 floats.

Pontoon motor mounting height. Motor height on pontoon boat. How To Mount A Motor On Pontoon Boat June 23 2021 by masuzi New toon kicker auxiliary outboard a trolling motor on pontoon boat add a trolling motor pontoon deck motor height pontoon forum get help. The normal rules dont apply to pontoons If you can see the anti cavation plate while your at WOT its.

Think of it as a wall of water on both sides of the motor. We have a new to us 2013 model 2375GCW with Express Package and strakes on both sides of all three toons. In fact unless you have a bunch of power say 100 hp or more mounting full down is the best setup.

Just mount the motor full down. Raising the motor increases the speed of the boat while decreasing the effort needed to turn the boat. However the motor should not be raised more than 5 inches above the standard position.

Keep these concerns in mind when buying a new pontoon boat or repowering your current boat. But post specs of your boat and motor and we can tell you for sure what it should be. The motor was too high but mounted as low as possible.

New boat builders are usually the only source for a replacement transom. Turns out some boat builders are letting transom height get closer to 21 inches or 26 inches. Most anyone can install trim tabs I did so thats got to be true if you take your time to do it right.

The height of the outboard is one of the most critical elements of setup and thats why outboards have a series of vertically aligned mounting holes on the motor bracket allowing for adjustment of the engine height. From what I understand about pontoons is the way to set motor height is to raise it a bit at a time until it starts losing prop bite then drop it back down. Delivering low-speed thrust 4.