We also offer pigeon boxes cratches hatches boat stretching.

Narrowboat overplating. Videos you watch may be added to the TVs watch history and influence TV recommendations. Cons of a Narrowboat Hull Maintenance. This video clip shows the next stage of overplating on a Narrowboat.

Side doors for narrowboats fully fitted or supply only. Kedian Engineering Ltd - We offer bespoke front rear. Welcome back to Canal Boat UK.

If playback doesnt begin shortly try restarting your device. Typical steel thicknesses are. Blacking the hull of your narrowboat is essential maintenance and needs to be done ideally every 2-3 years if using Bitumen or 5-6 years if using Epoxy finish.

Canal Boat Builders Narrowboat Builders Boat Fitters. Overplating is the normal procedure and is usually done without any interference with the boats internal fitting. Canal Narrowboat Overplating by JP Marine at Taylors Boatyard Chester After the vessel was lowered onto the new 6mm baseplate Canal Angels are dedicated to reporting Rogue Boat Builders and exposing dodgy repair yards across the country.

Increasingly though our commissions are for bespoke fully fitted widebeams. The sacrificial anodes should never be painted over when painting the lower part of the hull as this would prevent them from working. Overplating a Narrowboat 1.

Blacking the Hull. This narrowboat is on its journey to the workshop where it will be overplated. Most narrowboat builders specialise in all steel hulls with diesel engines to a variety of styles.