Then continue with a k2 p2 ribbing.↓↓↓↓↓↓.

Magic loop join in the round. Begin by casting on the required number of stitches. As a beginner, you are most likely familiar with working flat. To join the round, you’re going to work the stitch that *doesn’t* have the working yarn on it, with the working yarn.

To begin the magic loop method of knitting in the round, cast on as you normally would. To join in the round for magic loop, divide your stitches in half. Like this so there's going to be a step where the spiral begins and ends.

You can use this method with any cast on. A crochet project that is worked in the round can be started in either of two ways. Divide the stitches, then pull your cable up between the center, the loop of cable will be.

Just like the other ones, you want to cast all your cast on stitches on to one side of the. Arrange the needle so that. Carefully, pull the back needle out so that the back stitches are.

Second, you can create a magic circle. The greatest benefit to the magic loop method is that you can knit many different circumferences with one long needle. Now i'm going to show you how to join knit in the round using the magic loop method.

Holding the stitches in place with your fingers, pull. Turn your needles so that the yarn is hanging off the back needle. Slide the cast on stitches down onto the cord and find the.