If you are unable to get the door closed and the safety sensors are the issue, the garage door can be closed by pressing and holding the push button on the wall until down.

Line up garage door sensors. To give you the information on how to line up your garage door sensors, here are the following instructions. Once those are connected, move on to the white control wire. Disconnect power supply to the garage.

Pull the string taut and tie to the. Put the block of wood between the sensors and attempt to shut the. Disconnect power supply to the garage.

How do i realign my garage door sensors? Repeat with the other sensor. This sensor lets you check in from the ring app to see if your garage door is open or closed.

How do i realign my garage door sensors? Be careful not to scratch or harm the lens of the receiver sensor. Since it’s creation these garage door sensors have b.

If theres one component that cannot be overlooked in a garage door system it is the garage door sensor. Then, flip the breaker switch back on and see if cleaning the sensors fixed the problem. Press the button to operate the door.

All you need is a block of wood. In this video i show you how to realign your garage door sensors so that the garage door can function properly. Tie a string (long enough to span the width of the garage door) around the bracket on one side so that the string will line up with the sensor lens.