© 2023 american water heater privacy ® registered trademark/tm trademark of whirlpool, u.s.a.
Lighting whirlpool water heater. My problems started two weeks ago when the pilot light. Turn the gas knob to “pilot,” press and hold it down. Do you want to say thanks for the video?
If the pilot flame is not observed then the gas control knob is set to the off position, wait 10 minutes for the thermopile to cool. Change the temperature to low, and switch to pilot. Locate the gas valve at the bottom front of the heater:
Whirlpool water heater review and lighting instructions you resetting the honeywell gas valve on a water heater water heater pilot light keeps going out honeywell controller. It is in front of the thermostat depicted. Water heater flashing blue light 3/7/8 times meaning.
I took everything apart and clean it. Push on/off dial down, and. When relighting the pilot, the pilot light comes on, but immediately shuts off when.
Light the pilot using the instructions. Whirlpool gas water heater pilot light will not light up. The igniter works, no clogged, replaced the thermocouple.
Press the (thanks $ ) button near the like button to donate a few dollars. Keep the knob pushed in while clicking the button over and over again. All other trademarks are owned by their respective companies.