The grounding screw typically has a green head, but refer to the.

Installing vanity light. Consider a dual sconce for large vanities. It was wired in two halves and it occurred to me that if i cut it in half, i would have. Position the glass light shades on the vanity light and secure them in place with the included thumb screws or nuts.

Partially loosen the grounding screw on the new bracket. Follow these steps to install your new vanity light once you shut the power off: Use led bulbs to save.

How to install vanity light: Step 2 remove the old vanity light. Attach the four mounting brackets to the wall at each corner of the box.

To ensure that the power is kept off, use a small strip of tape to keep the light switch locked in its place. Place the two toggle bolts on either side of the lightbox and secure them with screws. Connect the wiring to install the wiring for the new vanity light:

To avoid dark spots at a long vanity, consider mounting a dual sconce in the center with single sconces at the outer. If it is not too old, you may be able to utilize the electrical wiring from the old fixtures. Take the light bulbs out of the existing fixture and remove the shades.

Vanity lights 47,612 views nov 14, 2014 upgrading your bathroom lighting is an easy project that not only. Attach the vanity light fixture. With your fixture’s backplate in hand, place it over the mounting screws so that their threads protrude through the backplate.