Installing a gas cooktop properly & safely will save your life!

Install gas stove top. After the power cord is connected to your range, turn off the main power circuit to the appliance. Install the gas cooktop burner caps and grille. Expect to pay about $15 to $25 per linear foot to run a gas line.

Attach the connector to the gas line. Buy the right gas stove connector. Install clips and brackets to hold cooktop.

As you can almost always trim a bit more bench top to make it fit. Get a new connector from a hardware store or home improvement. Spread a mixture of 1:1 water and dish liquid over each seam in your gas line.

Turn on burners and check gas flame quality and also gas burner igniter function. Turn on all of your burners for a few seconds to ensure that the gas lines are cleared. If bubbles appear, you have a leak.

Turn off your gas at the main valve one of the most important parts of this process is turning off your gas. Turn off the gas using the control valve, and unplug the electricity from the cooktop. Clips attach to your cooktop and snap into brackets installed onto the countertop cut out to hold the appliance in place.

Find the spots where the brackets are to be attached to the bottom of the cooktop and. Find your gas stove installation cost breakdown below. This quick gas cooktop installation video takes you from start to finish.