Run the wires from the transfer switch into the breaker box by denting commodious holes at any part of the box.

How to wire a generator into a breaker box. Then crew it tightly there. Attaching the conduit tube to the inlet box and the access hole. Run one hot wire on single poles and two hot wires for double pole breakers.

Install the two black wires each into the two colorless screws and. First, check that the double pole circuit breaker fits tightly in the panel. You will want it to be a few feet away from the generator.

Heath explains some of the ways that a portable generator can be professionally wired to a house. Fix the two black wires into these screws. Next, insert the 8 by 3 cable wire to the outlet you want to plug your generator in.

Ensure the engine throttle is in the right place and there is. Now, pass the wire through the conduit body and place the conduit tube between the inlet box and. There should be two screws without any color.

Install the breaker into the service panel. The red wire goes to one terminal on the breaker and the black goes to the other. A ground wire will also need to run through the same bar on which the circuit breaker is connected.

Fix the green wire into the green screw and tighten it very well for it to stay in place. How to wire a generator into breaker box. First, set up your inlet box on an exterior wall.