See the process to build a deck using deck blocks.
How to use a deck block. Mark the joist at the other end in the same manner and snap a chalkline along the joist tops. Dry fit the base cylinder into the deck block hole. Probably, the most commonly used technique is to install small pieces of material in a.
Blocking or bridging can be used for a variety of purposes in deck building. From here place your post into the tuffblock, connect the joist and post with screws and continue building the outer frame of your deck. A 1×4 piece of lumber is ideal for blocking, but some manufacturers may recommend a 2×4 instead.
Using dish soap, remove any oil or grease from the steel supports. In order to use concrete deck blocks, you will need: Square down from the chalkline on one side of every joist to provide a reference line for.
Doing so allows for a 10′ by 8′ deck using 9 deck. To make a better bond between the concrete and the block, wet the block. Dig holes for the deck blocks, making sure they are level;
Mark the location of the deck blocks on the ground with spray paint. Cut and lay your joists. Use a trowel to fill the hole and slots in the deck block with concrete.
Lightweight and easily modified with basic woodworking tools. While this means that the joist blocking spacing could be further apart (up to 4 feet),. To nail the joist braces into place use 10d.