Firstly, dig four holes, put in the posts, and.

How to string lights outside without trees. Lights to the posts, ladder for hanging the lights, and shovel. Arrange the planters in a rectangular pattern with at least ten feet between them, if necessary using cup hooks or cable ties. Now add dry concrete mix to the planters going about.

Clean the planters with a moist cloth and dry them thoroughly. Place the lights on the branches that are the thickest and strongest. Make sure you have enough to loop at each mounting point as it.

However, in case you have a deck that comes off the door, you can add just two posts. The first step is to take your tape measure and measure for space for your hanging lights and cable guide wire. Continue to apply additional layers of paint as needed to.

One end of the string lights should be attached to one. Make sure the pole is long enough to extend seven or eight feet above the ground. In the future, i think we will either invest in some proper string light poles or we’ll diy some proper.

Hot glue is being used on bricks, concrete, and stucco. Make sure they form a rectangle or square altogether. If you just have one strand of lights, you’re done after you attach the lights with cable clamps.

To get started, screw one hook into each post approximately 8″ from the top. Pick a glue gun that is safe for outdoor use and hang the lights with it. Pour cement into the hole.