When the pull cord breaks on your generator, you can start it without the pull cord by using a drill.

How to start a generator with a pull cord. As a general rule, a generator will be hard to pull start due to hydrolock in the cylinder, a malfunctioning recoil start. Then, get your generator ready to run (choke engaged, fuel valve open, etc.). It entails a rope and grip as the rope is pulled out for the generator to start.

You may need a flat screwdriver to reach. In fact, a majority of the generators on the market use this pull cord with a few using a key, switch or remote device. 1.remove the bolts that are holding the cover.

Pull the recoil cord until you feel a bit of resistance and then let it go back. If your generator has a recoil start then you need to pull the recoil cord to start the generator. Your knot should be almost.

Turn the fuel line on. Wrap the cord around the starter cup in a clockwise manner and leave yourself something to grab onto. Open the fuel valve and choke.

Open the fuel valve and choke. Pulling the rope might require more. Connect the rope’s two broken ends by tying a sturdy knot.

When the pull cord is operating normally, it is expected to come out when pulled outwards and retract back when released. If the engine doesn’t start,. You have to pull it until you feel some resistance.