From start to finish C.

How to rig outriggers on a boat. Push the leader line from the bottom into the tag weight and pull it up to the solid ring. A second length of mono line may also be measured out for a second tag line on the short rigger halyard line. Locate each outrigger base on your hardtop at least 2 or 3 feet in front of the most forward gunwale rod holder inside the aft cockpit and 3 to 5 inches inside the edge of the hardtop.

Make sure to thread the line through the same roller on each loop to prevent the lines from tangling up. Measure out a pole length of 400-pound to 600-pound mono line. If the riggers are straight out at 180 degrees to the boat returns may not be effective.

Fixed poles also tend to be heavier and thus disrupt the weight and balance of your small boat. Using the Taco rigging kit the job is really pretty easy. Measure out a pole length of 400-pound to 600-pound mono line.

Setting up and rigging outriggers can be intimidating the first time. This usually places the base somewhere aft of the lateral midpoint of the top. Ad But Did You Check eBay.

On the T-Top the pad eye is usually hooked on the outer t-top ring so it can be easily reached. Lets take a look at the things you will need to rig the Outriggers. If your pole has rollers attached to each loop.

Find It On eBay. Make sure the bases are positioned symmetrically the same on each side. Push the leader line from the bottom into the tag weight and pull it up to the solid ring.