Push the two cut ends of the drain body together.

How to replace shower drain cover. Using your flathead screwdriver, remove the screws. How to remove a shower drain cover / cap that doesn’t have screws. Insert the hooked end of the wire in the shower drain and start pulling out the hair.

Prepare a drain lubricant and a dry rag for this. The job takes about 30 minutes and doesn’t require any special plumbing tools. How to remove this shower drain.

Make sure to place them. Sometimes prying of the cover becomes problematic; Easily remove any shower drain cover & unclog drain in 1 minute!

Also tips on keeping your pipes from clogging!*tools & supplies below*mesh drain hair catche. Insert the screwdriver from the rim of the cover. Replace the drain if you cannot repair it.

Pull down on the handle of the screw gently but firmly to pry open. To find a drain cover the right diameter and screw hole pattern i had to buy a 2 abs g. Four “wings” flip out under the shower base to clamp the drain in place.

Once your shower waste is clean and free from any blockages, you can fit the new drain cover, simply by screwing it into place or clipping. The large compression nut of the shower drain body will drop down onto the pipe riser. Make a small hook on one side of the wire with a pair of pliers.