Remove the wire nuts attached to the existing solenoid wires and disconnect the two wires.

How to replace hunter solenoid. Attach the new solenoid in it's place and rewire. Check for any debris clogging the port where the solenoid sits. Make a note of the color of the two wires that the solenoid wires were attached to.

There are two ways to replace a valve, either replace the top (guts) only with new parts or cut the entire valve out and replace it with a new unit. Slide the solenoid and spring out of the housing. How to replace hunter sprinkler solenoid the egr solenoid is a small plastic switch that regulates the amount of vacuum pressure sent to the egr valve.

The solenoid is located on the top of the valve and looks like a cylinder with two wires. Remove the nuts located on the outside of the housing that secure. Now carefully line up the new top on the old valve, making sure that the solenoid is on the same side as it was on.

This solenoid fits all hunter valves. Wipe away this debris and rinse off the solenoid itself. Remove the three screws that secure the cover over the solenoid cover.

You will need to locate your valve boxes and twist the solenoid (s) on the valves clockwise until snug. Remove the new support ring from the donor valve, and place it in the old valve. While not a hard and fast rule, in almost every case this will provide a correctly.

It is normally attached to the engine. Connect the top assembly to the main valve body using screws and a screwdriver. Only a few parts can go bad on a valve, the.