How to fix drywall dents?

How to repair dent in drywall. Watch this video to learn how to re. Cut off two sections of paper joint tape, so that each length of tape will extend at least 2 inches beyond each side of the hole. Cut your support to 2 or 3 inches longer than the width of your opening.

Apply a layer of drywall compound to the dented area using a putty knife. How to fix a huge dent/bent in the drywall. Cutting the drywall with a box cutter.

After the joint compound has dried, apply additional. Apply the paper joint tape. Pick up a tub of drywall mud and grab a putty knife from the hardware store.

This is part one in a series about repairing drywall in your home. In a small bowl, mix 4 parts joint compound and 1 part water. Press a piece of mesh drywall tape into the wet compound.

Allow the patch to dry and check for shrink back. Here’s how to do that: Prepare to sand the patch area.

Apply the stencil to cut a hole around the dent. Then, angle your support to fit it through the hole and inside the drywall—roughly in the middle of the. The nail pops, you could put another nail next to the one that’s sort of stuck out and drive it in.