A short tutorial on installing dirt bike graphics quickly and easily.
How to remove dirt bike graphics. First, heat up the air bubble with the hair dryer. First, clean up the plastic part completely to remove all dirt, oil, old graphics, and old glue. The problem with old decals is that they’re cold and dry and brittle.
It will also activate the sticky part of the vinyl. Start by heating up the graphic with a heat gun or hair dryer. Check the plastic alignment of troughs, winds, curves and edges of the graph.
Smooth the bubble down using your finger. After being actually subjected to the sun for an extended amount of time dirt bike graphics are actually. Use as much tape as you need.
If there are old graphics on the bike, they’ll need to be removed. Work from the center outwards to. So trying to peel them off when they’re like that is.
Remove the paper back of the vent and the bolt hole from inside. Remove the stock decals and graphics from the rear of your dirt bike. Work in a warm space, at least 20 degrees celcius.
Using adhesive paper tape, tape down the decal to the plastic. Dual sport ride, hare scramble, enduro race, adventure ride, and motocross race. After being actually subjected to the sunlight for an extended amount of time motorcycle graphics are actually heading to be.