Use a 7mm spanner wrench to tighten the nuts better and secure them in their places.

How to put skateboard on wall. The best skateboard deck wall mount. In the last step, just place. These two additional bolts mark the gap between.

Next, add in nuts, one on each bolt again, about halfway. It’s best to have a drill with a 3/8″ drill bit and a hammer drill to make sure that the holes. Peel the backing off of one side of an adhesive strip.

Make a mark on the wall where you want your screw to go in. The length may vary dependent on the skateboard, it needs to fit around the wheels of the board after allowing for the two. Bear in mind that where the screw is will be slightly above the top holes of your board.

There you have it, a. As i discussed in the requirements, using the original adhesive strip. Use colors, backgrounds, texts and upload photos!

This is a quick and easy way to do it. Place a washer over each of the bolts on the front side of the plate and secure them with a nut. Take the shoelace and place it to the.

A spanner can be used for tightening these nuts. The fishing line is a common and old method that is. Instructions get an old magazine or newspaper cut out a rectangle about the size of your skateboard flip over your board and find out where you will place it on the wall.