Steps to prime a shallow well pump:

How to prime shallow well pump. Though specific details can vary, priming a well pump requires you to turn off the pump, and remove the plug. After checking for damage, shut off the power source for your well and make sure the pump is fully disconnected. Cost of power dug well:

Fill the water pump slowly. Fill in the pump casing until the water comes out from the prime plug and release valves. Check all the valves by operating them.

Disconnect the well pump from all power sources. Locate and remove the prime plug,. Follow these four steps and learn how to prime a water well pump:

Turn the pump off and disconnect it from electrical outlets. All you have to do is follow these simple steps: Run a water hose to the exposed hole on the top of the pump.

How to prime a shallow well pump. If your well pump won’t prime, damages to the well pump itself could be the reason why. Steps for priming a well pump 1 shut off the pump completely disconnect the well pump from the electrical outlets.

Step 2 run water through the water hose and into. Take the plug out and run a water hose to the open hole where the plug was. Step 1 remove the rubber or plastic prime plug from the top side of the pump.