Then, you will need to open the release valves and use a clean hose to fill the.

How to prime a well water pump. Closing vents and supply line: Fill in the pump casing until the water comes out from the prime plug and release valves. How to prime a water pump.

Some types of plugs have plastic. You must first unplug the water pump loosen the nut on the front of the pump fill the water pump slowly. There is always a rubber prime plug located at the top portion of the pump.

This will prevent pressure buildup. To start with, disconnect the power source and remove the plug as. 2 check the pump check for any visible damage, cracks, or.

Open the recipient building water shutoff. Using this procedure you may need to prime the pump a time or two before you tighten the plug. Ideally, you want about a gallon or two for priming your water pump.

Run a water hose to the exposed hole on the top of the pump. This can depend on how deep or shallow the well is and if there is any existing water pressure in the. All you have to do is follow these simple steps:

Turn on the water and let it pass. Step 2 run water through the water hose and into. It is important to turn the electric off when you go to prime your well pump.