Step 5, run the household water.

How to prime a submersible well pump. Then connect the other end. 2 check the pump check for any visible damage, cracks, or. The water you use to prime your well pump will need to be the same as the intended use for.

Turn on the water and let it pass through the water. Follow these tricks for lowering a submersible pump using a grinder to remove the sharp burr on the top edge of a steel well. Next, grab your water hose and attach it to the hole where the priming plug used to be.

Insert the prime plug in. Locate and remove the prime plug, which is usually on the head of the. Steps for priming a well pump 1 shut off the pump completely disconnect the well pump from the electrical outlets.

Follow these four steps and learn how to prime a water well pump: This will prevent pressure buildup. It should be fairly easy to attach and screw on, like a regular garden hose.*.

Fill the water pump slowly. Connect one end of the garden hose to the donor building water source. Run a water hose to the hole where the prime plug was.

Install a submersible pump lesson#4: Take the plug out and run a water hose to the open hole where the plug was. Turn the pump off and disconnect it from electrical outlets.