A continuously running pump can result in a massive electric bill.
How to prime a deep well jet pump. Turn on the water and let it pass through the water. Once you’ve fully filled the casing, put the plug back in. Open the priming port on top of the pump and fill it with water.
Locate and remove the prime plug,. If you've lost pressure in your well,. Priming a well pump for this type of setup is not an issue because these pumps are.
It should be fairly easy to attach and screw on, like a regular garden hose.*. A leaky foot valve or check valve can cause the pump to lose its prime or to run continuously. Slowly open the suction isolation valve and the air vents on both the suction and discharge pipes.
Once the pump is primed (you'll hear it),. Inspect the pump and connectors for damage or cracking. 1 completely turn off the power 2 remove the casing and the vent plug 3 pour running water into.
Locate and open the release valves. You may have to do this several times. Close the valve, prime the pump, replace the priming plug and leave it loose (to let the air escape).
Next, grab your water hose and attach it to the hole where the priming plug used to be. This will prevent pressure buildup. Turn off the pump and disconnect it from any electrical outlets, or turn off it’s circuit.