One is used to apply pressure on the bolt, and the other is used to lift the levers.

How to pick a key door lock. Apply minimum torque to the tension wrench, insert the bobby pin into the keyway, make use of a vibrating motion, or scrubbing over the pins, after a few se. Very gently begin to raise each pin and gauge how it. This will make the gun to start vibrating, and as it vibrates, the pins.

For best results, insert the paper clip and press it as close as possible to side of the lock that faces you. Car door locks do not use a pin tumbler locking mechanism. With curtained locks, there is a little gadget known as a.

Installation of lock involves the following steps; After that, clean the location of. Now, enter the combination to open the lock.

Insert your hook type pick into the keyway and push it all the way to the back of the lock until you locate the rearmost pin. Apply rotational pressure in the direction you would turn the key to unlock. Step1) find the lock’s “ deadbolt ” or main door handle.

Insert the card between the door and the door frame. Whichever will not block the keyway. Simple lever locks can be picked with two pieces of wire, bent at right angles.

Instead, these locks are usually wafer locks and sliders. Insert your tension wrench into the bottom or top of the keyway. Then, press the “c” button to clear the combination.