Space nails a maximum of 16 inches.

How to overlap vinyl siding corners. I have recently installed vinyl siding on an old addition of my house. Leave a 1/4” (6.4mm) gap at the top of corner posts. Build the corner out of 1x or 2x depending on standoff preference and wrap it with coil stock.

Seal small cracks and gaps in your siding, under 1/4 inch wide, using an acrylic latex caulk. Place all other nails in the center of the. Vinyl siding leaking at corners.

Measure the length of the wall's corner with a tape measure, starting 1/4 inch below the eaves and ending 1/4 inch below the starter strip. As a general rule, the lower you will install your vinyl siding, the better. Overlap 3/4, allowing a 1/4 gap between the nailing flanges for expansion.

Lay a new piece of corner siding on a flat work surface. How do you seal the corners of siding? Finish off the final course at the top of the wall.

Start nailing vertical siding and trim pieces in the top of the uppermost slots to hold them in position. Lap away from the highest traffic pattern, typically the front of the house. Thanks for the info:, found their version on page 22, instead of 18.

The slab is not level. Place the corner post in position, allowing a 1/4” (6.4mm) gap between the top of the post and the eave or soffit. Simply apply this inexpensive filler into the cracks to seal.