It rests in a groove on the bottom edge.
How to move a howard miller grandfather clock. Be sure the hook on top of each weight is tight by turning the hook clockwise. Grandfather clocks by howard miller grandfather clocks and other quality mantel clocks wall clocks weather clocks curio cabinets and curio cabinets. Start off by taking out the base of the howard miller grandfather clock, and place the howard miller grandfather clock where you want it placed.
The time keeping of a normal mechanical grandfather clock is adjusted by changing the length of the pendulum. Located in the bottom of. Remove any shelves from inside the grandfather clock and wrap them individually in soft packing paper and bubble.
Take a plastic bag and put. How to setup a howard miller grandfather clock Lift the top side panel up.
That length is normally adjusted with a. To do this, move it every 15 minutes until it strikes the hour. Hang each weight on the pulley in the.
Open the gate of the. Hook the pendulum in the slot as shown. Unpack and hang each weight according to its corresponding side (left, center and right).
Push the bottom edge of the top side panel toward the center of the case while at the same time, pull the top. You are careful not to release all tension as the cable or chain can. Place it back in and see if that does.