To begin, cut a piece of wire a few inches longer than the finished bracelet size.

How to make beaded bracelets with clasp amp. You've made bracelets, now how about making clasps to go with them? 1mm waxed linen cord (mine is black) size 6/0 seed beads. Macrame artisan monica over at the smitten by a knot blog.

Steps to make a bracelet. This design is easy, because the eye is not going to count the beads to make sure you are consistent with the sizes of the. Pull the wire through the crimp bead.

There is a total of 18 bead colors with a total bead count of 2250 beads 25 beads by 90 beads. How to make a beaded macrame bracelet with sliding clasp. Thread a crimping bead onto the end of the beaded bracelet, along with a lobster claw clasp.

Tighten your knot from all sides. Let's take this a step further and extend the design into the clasp. Pull the top two ends to tighten the knot, pull from the beaded side, pull the left loose end and the right beaded end and vice versa.

We do not own or host any. How to make easy diy adjustable bracelets with beads without clasps 1. Feed a crimp bead onto the end of your wire then add your lobster clasp.

Continue to thread beads in any order until you reach the length desired. When cutting your thread for this bracelet, just wrap it around your wrist however many times you. Use a side cutter to cut a piece of beading wire to the desired length.