Fooling the garage door sensors is very simple.

How to line up garage door sensors. Since it’s creation these garage door sensors have b. Locate the two sensor eyes at the bottom of the garage door track on either side of the door. Disconnect power supply to the garage.

Your hand and a screwdriver. Once those are connected, move on to the white control wire. Slowly rotate sensor back, aligning sensor with sending sensor, until it lights up green again.

Do the same on the. The knot you make should be very tight. This is a temporary solution to the problem.

Disconnect power supply to the garage. The universal beam sensor works with all major brands of garage door openers. Repeat with the other sensor.

If theres one component that cannot be overlooked in a garage door system it is the garage door sensor. To give you the information on how to line up your garage door sensors, here are the following instructions. In this video i show you how to realign your garage door sensors so that the garage door can function properly.

Connect the new sensor to the old white wire using another blue wire nut. First, close the garage door and disrupt the power supply to the automatic door opener. When you have a strong green light, put it back into the bracket and put the wing.