How to relight the pilot light on a rheem gas water heeter and get your hot water heater going.note:

How to light the pilot on a water heater. This ignition button is sometimes red. If your hot water heater is a manual, grab a long lighter. Keep pressing the ignition button once per second while holding the gas control knob down.

If the pilot light goes out, repeat the process above from step 3. You can find it on the gas valve’s handle, underneath the burner compartment panel. On most water heaters, this will be a small box with a few knobs near the base of the heater.

Turn the gas regulator valve to reach. Turn the control valve to “on”. Right after a second, press the ignition button till the status light begins to.

How to light a water heater with electronic pilot: After removing the metal plate covering the pilot button, scan the. Next, i’m going to continue to press and hold the dial in the pilot setting and also start to press the igniter button below it.

There will be a red or black button marked “ignition,” press it for about 60 seconds. Hold down the “pilot” button: To turn off the gas, find the gas regulator valve.

Keep an eye on the status light and keep going with the process until it starts to. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air. Keep holding down the pilot knob or button for at least a.