Push down the red button to the left of the gas knob.

How to light rheem water heater pilot. On a modern rheem gas water heater, it is very easy to light the pilot light. Here here’s how to light the pilot light on a rheem gas water heater. Depress the control knob fully and keep holding the knob down to allow sufficient gas to flow to the pilot light.

If you feel uncomfortable lightning your own water heater call a professional. After doing so, disconnect your rheem water heater from its power source. How to relight pilot light on rheem water heater a faulty thermocouple or malfunction of the gas valve could be the culprit, but the problem may be as simple as a.

Turn the control switch to pilot light mode. How to relight the pilot light on a rheem gas water heeter and get your hot water heater going.note: If there is dirt and debris accumulation in the gas chamber, air can’t flow into the chamber.

Listen for a click and the water. Your rheem water heater pilot light won’t light due to a dirty gas chamber. Press the red control button in for a few seconds and while pressing in, button every few seconds.

To reset it, you want to turn it in the off position. Hold the red button down while pressing the piezo ignitor striker, found to the immediate right of the gas knob, repeatedly until. Turn the gas control knob to the pilot position.

Depress and hold down the pilot set button or gas control knob. Rheem water heater light is not blinking because of the turned off combination gas control, pilot is not lit, and insufficient power supply. I have a rheem classic residential water heater.