When you want to light an electric pilot on your water heater, it’s recommended that you first switch off the electricity at the breaker.
How to light pilot water heater. Locate the cover for the pilot light: Then turn the heat dial to the pilot. This cover is usually located just below the gas valve.
On a modern rheem gas water heater, it is very easy to light the pilot light. This will blink when it’s turned on. To light, a water heater with an electronic gas pilot, turn the gas knob to the “pilot” position.
This is because when power is turned off, the. Smith water heater might go out due to an interruption of service or repairs needed on the appliance. Hold down the “pilot” button:
Press the (thanks $ ) button near the like button to donate a few dollars. Once you open it, you should see the burner. Do you want to say thanks for the video?
This ignition button is sometimes red. Turn the water heater to the pilot position. Buy a new one that matches the old one in size and length.
There will be a red or black button marked “ignition,” press it for about 60 seconds. Make sure you know where this is before you. This is normally done by turning the dial so that the word pilot so that it is facing the.