Light the pilot using the instructions.

How to light pilot on whirlpool water heater. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air. Whirlpool gas hot water tank pilot wont light easy fix you Keep the knob pushed in while clicking the button over and over again.

© 2023 american water heater privacy ® registered trademark/tm trademark of whirlpool, u.s.a. For 90 seconds, hold the knob in and click the igniter button over and over again until the light. You’ll want to watch it as you work.

In order to start the pilot, you need to make sure that the knob on the gas control valve is fully pushed in. Push the “pilot light” button next to the knob. Whirlpool gas hot water tank pilot wont light

All other trademarks are owned by their respective companies. Steps to lighting water heater pilot. Push in the knob and hold it in.

Turn the control valve to “on”. If the pilot flame is not observed then the gas control knob is set to the off position, wait 10 minutes for the thermopile to cool. If all goes well, you should.

How to light a water heater with electronic pilot: You can also try to clear the vents on the. In this video i walk you through.