Whirlpool water heater diagnostic led light codes.

How to light a whirlpool hot water heater. Remove the cover on the energy. On the top of the gas valve will be a dial that says on off & pilot. • green led will signal normal operation.

Your heater may be fast enough that the burner can be done in less than an. Keep the knob pushed in while repeatedly clicking the. Make sure the water heater’s power is turned on by checking the breaker.

Locate the gas valve at the bottom front of the heater: The pilot light in your water heater is a small device that is designed to provide the flame to light the gas released out of the gas valve and main burner. Check for leaks from the tank to see how to troubleshoot a whirlpool electric hot water heater.

When lighting the pilot, make sure the knob on the gas control valve is fully pushed in. Troubleshoot a water heater that puts out overly hot water. Keep the knob pushed in while clicking the button over and over again.

Open the drain valve with your garden hose. To check for power, turn the circuit breaker marked water heater off (or remove fuses). Whether your water heater is running or.

Push the “pilot light” button next to the knob. It is in front of the thermostat depicted. The green/red led light indicates the status of the electronic thermostat (see figure 10a).