Turn off the thermostat, remove a few panels to locate the pilot light, light it a.
How to light a pilot light on a nordyne furnace. If your pilot light goes out, all you need to. Set the thermostat to the lowest possible temperature (or turn it off) for a safety measure. Call cranney home services for gas furnace repair.
Lighting a furnace pilot light Wait at least 5 minutes to allow any remaining gas in. The pilot light in a gas furnace is a continuously burning flame that ignites the burners.
Once the gas dissipates, turn the knob to “pilot.” then, hold down the “reset” button, bringing the flame of a long lighter close to the pilot light opening. When the pilot light is hot enough and working correctly, the main gas valve in the pilot assembly is kept open by what’s called a thermocouple. In principle, lighting a furnace pilot light is not terribly complicated.
Turn the pilot switch to the “off” position. Find the instructions label on. Wait for 10 minutes for the furnace to fully shout down.
This will stop the flow of gas into the room. A thermocouple is an electronic device that monitors. Turn the knob on your furnace to “off.”.
After a power outage furnace will not come on and pilot light will not relight. In this episode of repair and replace, vance shows how to relight the pilot light, in a standing pilot furnace. Place the lit match or ignited lighter tip at the pilot while depressing and holding the reset button or depressing the knob, as appropriate.