If the level is below the skimmer mouth, then we have a leak in the pool.

How to level above ground pool with water in it. You can do this by placing the shovel’s tip under the lip of the slab and pushing the shovel’s handle. You should have a hole left where you lifted it. With the help of the shovel, pry the wall up from the base connector.

Since there is so much weight on the wall, this is a vital step. Check to see that the edge is level with the rest by using a. Following that, you can start to lift the pool.

Mark the perimeter of the area to be leveled. Tie a spray paint can to the other end of the string. If the pool is full with water, drain it.

Take a handful of soil and make sure it is slightly wet (so that they stick together) then carefully insert it into the cavity. Now you can start the leveling processing: First, you need to drain the water from your pool halfway.

Drain your pool (but not all the water). If it’s not packed tightly, the pool will shift, and you’ll have to do it all over again. This can corrode the pool’s metal parts,.

This will help ensure that your pool legs don’t slide or. The first step is to take your garden hose and use it to drain some water from the above ground pool. You will need to repeat this process for every set of leveling blocks on the lower side of the foundation.