Open a water faucet to test the pressure.
How to install water pressure regulator. Once the assembly has cooled, reinstall the pressure. Once the right place to. When the water enters the regulator at high pressure the inner mechanism constricts the diaphragm to narrow the flow of water.
You might wonder how i can write an entire post about “installing” a water pressure regulator when, really, there is only a single step. Use your wrench and unscrew the large fitting from. Brush flux onto the ends of the valve assembly and onto the ends of the water pipe.
Find a location for your regulator. Tighten the lock nut back into position when the adjustment. Check and adjust the pressure to the desired levels, then turn back your water on from the mains.
The water pressure regulator pack should contain enough information on how to install it. Readjust the regulator as needed. This is the last step when installing a water pressure regulator.
Be careful to only cut out the length needed. Prevent damage to your plumbing and waste due to excess pressure in you irrigation system by installing a water pressure. Typically this is right before the main.
After the water is turned off, remove the pipes from their nipples. Screw the regulator on to the end of your. If you are comfortable enough to install the regulator yourself, follow these steps: