For instance, an 8’6” garage door cable will be required for a 7ft garage door.

How to install garage door cables. Place and assemble the cable correctly in the slot of the cable drum. Then, carefully pull it up to the cable drum at the top of the door on both sides. A garage door cable installation requires some vice grip or some locking pliers, along with the right replacement cables, winding bars, sockets, wrenches, ratchet, and a step ladder.

Open your garage door and lock it the replacement procedure for extension spring cables is essentially the same as with torsion. Wind the cable onto the drum cable and then immediately slide its drum cover to cover the bearing plate. Secure and close the garage door.

Screwing the wires properly can be done with the door closed. Diy garage door parts bonus tip: Before we start, if your car is in the garage, we recommend you remove it and.

Vertical track for convenience, we. Connect one end of the cable to the garage ceiling; How to install garage door springs and cables step 1:

Open up your garage door, and then use one of your vice grips below the roller on both sides. Take all of the cables out of the cable drum. Ensure that the garage door is closed.

The cable size will be determined by the size of the door. It does this by reducing the likelihood of the cable rubbing against the cable drum as the door opens. Disconnect the garage door from the garage door opener so you can close or open it manually.