How to install a water heater with sharkbite's water heater connectors 334,997 views aug 4, 2011 sharkbite's flexible water heater connectors make installing water heaters.

How to install flexible water heater connectors. Flexible gas appliance connector should be installed in gas line close the water heater and its gas connections. For fip x sweat installation: You should also connect the push that fits the.

After getting the right length, use the wrench to install one of the. Box up & save 20%. The material used to make the flexible gas connector is very easy to cut so it should not present any problems.

Mark the tube at least 2” below the push fitting end on the copper tube. Loosen nut approximately half a turn and slip compression fitting over copper pipe until it meets internal stop. Starting with nut (a) closest to heater, wrench tighten nut ¾ to 1 full turn or until firmly sealed.

If your existing gas pipe has csst (corroded stainless steel. Snap the new draft hood onto the. I have to replace my water heater.

Never use a reducer, even if the hood’s opening is smaller than the vent pipe. Connect the vent pipe to the hood with sheet metal screws. This article summarizes manufacturer's advice for the.

You should connect the flexible water heater to the electric supply, water supply, and other connections. The old heater is connected with 3/4 inch rigid copper pipe and solder connections. You must also use the 1” for a ¾” nominal pipe.