All of our systems are good for homes with up to 6 bathrooms.
How to install a water softener and filtration system. Also, be sure to open any faucets that are nearby to get rid of any lingering. Next, place the filter where you want to have it. Attach it to your softener at one end and to a floor or sink drain.
To do this, you will use your hacksaw to cut out about a 6” section of the previously mentioned water loop that’s the closest to your water softener. Turn off the water main or isolation valves (if fitted either side of filter) , bypass can be opened to maintain supply (if installed). The hoses will have threaded fittings that match up with your softener’s corresponding fittings.
You will then attach the ½”. Locate the drain valve on your softener system and connect it to the drain line. The best way to do this is by opening the lowest valve in the house and letting the water run out.
This will ensure that there’s no backflow in the softener unit. Whirlpool® water softeners come with everything to install and hook up to 1” npt (national pipe thread). Connect the inlet and outlet hoses to your softener.
Turn off your water supply at the main line. Between the user manual that comes with your harmony water softener and our youtube channel, just about anyone can install a new system in their home. If your plumbing is smaller or larger than 1”… before you get started:
Gather your tools, including an adjustable wrench, utility knife, bucket, bleach and water softener salt. You need to establish a connection from the incoming water supply to the inlet port of the filter system and a connection from the. Tier1 everyday series 48,000 grain high efficiency digital water softener.