Solder the valve assembly to copper water pipe.

How to install a water pressure regulator. A step by step guide on how to install a home water pressure regulator.please make sure to turn off main water line before installation.typically this is rig. Fasten it onto the fittings. Make sure that the water is completely drained by running.

Install a new water pressure regulator. Prevent damage to your plumbing and waste due to excess pressure in you irrigation system by installing a water pressure regulator at the water meter. When the water enters the regulator at high pressure the inner mechanism constricts the diaphragm to narrow the flow of water.

The spruce / michela buttignol. Allow the water to run for a minute. If you are comfortable enough to install the regulator yourself, follow these steps:

It’s a way to safely regulate the pressure of the water you use. Before you can begin installing your valve, it is vital that you ensure all your water is turned off. Water pressure regulators are installed where the main water line comes into the house, just past the main shutoff valve.

Readjust the regulator as needed. Taming extremely high water pressure with this old house plumbing and heating expert richard trethewey. Brush flux onto the ends of the valve assembly and onto the ends of the water pipe.

Turn off the water at the main and right before the water heater. Install a pressure regulator valve: The process is as follows: