You want to apply it in a spiral.

How to install a superstroke putter grip. One method where you’ll damage the grip as little as possible is by injecting solvent beneath it using a needle. To remove a superstroke putter grip, use pliers. This will be fairly easy.

I make sure to really wet that part of tape. For all super stroke countercore grips, watch this instruction video: Please put any questions or comments here.

Tuck the tape hanging over into the shaft. Designed in close collaboration between superstroke and arccos engineers, the superstroke putter grip accessory allows for the seamless attachment of an arccos caddie putter sensor. This ensures that the grip easily slides over the wet tape on the.

Gently twist the pliers around the grip until it pops free. This grip was installed on a scotty cameron red x. The top of the grip is about an 1.5″ wide and flat from top to bottom.

When you see the handle loosening, use. How to install your weighted putter grip from super stroke. Thanks to the blowing air, the adhesive between the handle and the shaft will dry.

For super stroke grips without countercore technology, watch this installation video: You use the compressor to put the clubhead to let the air in. It can be done in a few different ways.