Then, using a drill, make two pilot holes at the top of the board on either side of the centre mark.

How to hang up skateboard deck. Make sure that it doesn’t go too far, or else your deck and display will fall if you hang it. Hold the display against the wall and align the hole at the center with the one you drilled in the wall. How to hang up a skateboard conclusion.

Now that the walls are ready and marked, it’s time to stick the plastic hooks. Thread both of the long bolts through the back of the plywood plate. First of all, take a wall strip and take off the cover from either side.

If you want your deck to be hung, you’ll need to drill a hole in the wall. Make sure it is free of any dirt, grease or debris. Here are some ideas on how you can hang your skateboard deck on your wall.

The plastic wall anchor should be inserted into the hole to hold the. It is quicker and easier to go straight ahead with the nails but you will notice the difference if you measure. Attach a wall anchor by drilling a hole in the wall.

As i discussed in the requirements, using the original adhesive strip may not. Hang up a skateboard deck 07/18/2011. A screw should be included with your deck display.

Next up, you need to measure the distance between the holes in your skateboard deck (where the trucks go). Once you have the measurement, you will need to draw two dots (the. You can use a 7mm spanner to.