Every 6″ or so is adequate.

How to hang pictures on plaster walls. You will need an electric drill with a variety of drill bits, and screws or classic picture hangers. Take the covering strip off the back of the hook, then stick it to. If the pictures are small and equipped with a wire on the back, use a small picture.

Place duct tape on the spot. To use them, follow these steps: In this diy video, i’ll show how to hang stuff on plaster and lath walls using a molly bolt.

First, make sure you have a clean wall surface (use soapy water or rubbing alcohol and leave it to completely dry). From here you will lightly tape in the molly bolt. To hang pictures on horsehair plaster walls, follow the below steps.

A great addition to any room, and can really help to personalize your space. For pictures weighing five to 10 pounds, drive your nail or hook at a. Sew the mesh through the wall as you would everywhere else (18″ on center both directions) to tighten the mesh around the backers.

Drill a small hole in the wall, and note if you hit wood or not. Mark the wall stud areas with masking tape. Take a picture hook and.

If you’re looking to hang a picture on. How to hang pictures on plaster walls. I prefer if the screw hits the wood lath behind the plaster.