When hanging the brackets, they should be.

How to hang curtains on a cement wall. Place a curtain rod bracket in the desired spot on the wall of the block. Mark holes for hanging the curtain bracket. Below are the steps to follow if you opt to drill curtain hardware on the concrete walls.

Bars pass through the rings to keep. If the level is not long. Try positioning the curtain rod near the ceiling.

Then, use a hammer to tap in place of a square pole. Use a pin and fold the curtain at the position where you made a. When you hang the curtains, this will ensure that the window is entirely covered.

Place a level on the installed hardware and hold the edge of the hardware for the other side against the mark on the cement on the other side of the window. First, use a power drill to make a pilot hole in the center of the existing nail head. The plastic brackets for the curtain rod should be attached to the wall using a tape measure.

Position your mounting hardware on the spot where. Use a curtain’s hanging rod. Next, use a mallet to pound the peg down to keep the.

Wrap the drapes around the rod. To begin, measure the cross dividers and locate the location where the curtain rod will be installed. Measure where to hang the brackets.